selector switch

[robnix]

Any tricks to getting the selector switch spring and ball detent back in an emag without losing anything?

[Tunaman]

Any tricks to getting the selector switch spring and ball detent back in an emag without losing anything?

I'll give out one of my tricks...
Find an allen wrench that fits in the little hole. Rub the allen wrench on the trigger magnet to magnetize it. Put the ball and spring in a plastic lid or tray of some sort so you dont loose it.(I use the tops from cans of Pringles) install the selector switch almost all the way in and hold it there while picking up the spring with the allen wrench. Lower the spring down the hole. Pick up the ball with the allen wrench and lower it down on top of the spring, keeping it centered onthe allen wrench and spring. Start pushing it down while holding your thumb over the large frame hole so if you screw up it wont go flying. Push the spring and ball down and pull out the allen wrench while pushing the selector switch in at the same time. All this takes 5 seconds to do.

[robnix]

I'll give out one of my tricks...
Find an allen wrench that fits in the little hole. Rub the allen wrench on the trigger magnet to magnetize it. Put the ball and spring in a plastic lid or tray of some sort so you dont loose it.(I use the tops from cans of Pringles) install the selector switch almost all the way in and hold it there while picking up the spring with the allen wrench. Lower the spring down the hole. Pick up the ball with the allen wrench and lower it down on top of the spring, keeping it centered onthe allen wrench and spring. Start pushing it down while holding your thumb over the large frame hole so if you screw up it wont go flying. Push the spring and ball down and pull out the allen wrench while pushing the selector switch in at the same time. All this takes 5 seconds to do.

Awesome, love the magnet trick, thanks Tuna!

[Tunaman]

you must also hold the selector switch in the position that it normally sits in Emode. This gives the ball an easier time sliding under it.

[robnix]

you must also hold the selector switch in the position that it normally sits in Emode. This gives the ball an easier time sliding under it.

Thanks again!