Pnuemag help-quick!

[Big Boy]

OK, it's for sure a problem with the sear, or on off. The sear simply wont go low enough to let the bolt go forward. I put the valve on the rail without the body so I could get a look at everything and that is it. The sear just barely wont release the bolt. I really gotta get this thing shipped, any ideas?

[blinky1041]

Check to see if there is anything hindering the movement of the sear in the rail or frame.

[steiner79]

Your Sear Is Probly Hitting Your Actuator Not Allowing Full Movment Position The Actuator Down Futher In The Frame
I Had The Same Problem When I Started My Pnuemag

[RRfireblade]

Try replacing the bottom o rings in the on off.