new emag not working!!!!

[danny23917]

so i just got my first emag last night and finally gased it up today. But the electronic mode does not work...The battery is fully charged, the menu comes up and the screen shows it is registering my trigger pulls (the is in the "E" mode), but the gun wont shoot. the gun shoots perfect on "M".

i dont know much about emags, but when i took it apart the solenoid wasnt pushing down when i fired in e mode. keep in mind the board is registering the trigger pull but it wont depress the noid. everything works great in mech mode though...
pleeeaasee help this is not the first impression i should get from such a sick gun
!!


btw heres a pic of the board beecause i dont know if somethings messed up or not connected there

[olinar]

i cant tell from the pic but is there a third wire running with the red and yellow.those connect to the hall sensor and could affect the solenoid.

[Pneumagger]

see if the frame cycles apart from the gun. Your noid may be shot (don't worry their cheap).

[danny23917]

yea sorry about the bad pic... camera phones suck
anyways there is a third black wire running with the red and yellow

what do you mean by the frame cycling apart from the gun?

[Tunaman]

Make sure the battery has 18+ volts in it or it isn't any good. Check the ground lug and board mounting screw. Let me know.

[Pneumagger]

yea sorry about the bad pic... camera phones suck
anyways there is a third black wire running with the red and yellow

what do you mean by the frame cycling apart from the gun?

take the frame and sear off the rail... then see if the noid has force. if it has no force on the plunger:
a) shot solenoid <--- measure voltage delivered to the actual solenoid
b) not enough juice form the battery. <--- measure voltage from battery
3) Power short somewhere on the way to the noid. <--- cry

[robnix]

Do you have the Xmod software installed?

[danny23917]

tunaman was right..thnaks a lot man...
now my on/off is messed up (is the pin supposed to be free moving or seem spring loaded)? thansk again

[danny23917]

so now its leaking out of the on/off...and the pin seems loose(like not spring loaded), could it have blown an o ring or is the whole assy messed up??

[Tunaman]

You must explain what you mean by "assy"...

[Rudz]

You must explain what you mean by "assy"...

assembly? but which assembly

[danny23917]

i mean the on/off, it leaks and falls out when i take the valve out from the body, the pin is also loose...any ideas??

[robnix]

i mean the on/off, it leaks and falls out when i take the valve out from the body, the pin is also loose...any ideas??

Do you have air in the line when you remove the valve?

[danny23917]

nope

[robnix]

nope

Missing any o-rings? In all the 5-6 valves I've used I've never seen the on/off and the pin just fall out. Is the pin staying in the valve when you pull the on off out?