4500psi remote line

[AHung]

Are there any remote lines that are made to connect to 4500psi tanks. I have been shoppin around but all the remote lines I find are either 3000psi or unspecified. I am tryin to make a low profile, woodsball/scenario marker that is balanced in terms of weight and easy to maneuver with.

My setup is:
Tac-One w/ warp left body (factory level 10 and barrel)
88ci/45 HP Crossfire (Vest to hold it on my back)
500 shot Q-Loader system

Im also open for suggestions that would improve my setup.
(kinda new to paintballin in general but im learnin )

[lasrsktr]

Are there any remote lines that are made to connect to 4500psi tanks. I have been shoppin around but all the remote lines I find are either 3000psi or unspecified. I am tryin to make a low profile, woodsball/scenario marker that is balanced in terms of weight and easy to maneuver with.

My setup is:
Tac-One w/ warp left body (factory level 10 and barrel)
88ci/45 HP Crossfire (Vest to hold it on my back)
500 shot Q-Loader system

Im also open for suggestions that would improve my setup.
(kinda new to paintballin in general but im learnin )

To my understanding you will only be passing 850psi through the remote line since the reg on the tank is stepping down the 4500 psi to 850 psi...

So the 3000psi rated remote should be perfectly fine.

[AHung]

Was just thinkin bout that too, thanks.

Do slide checks starve mags? heard something about that

[Reaper_de_Grim]

slide checks

I run remote with a slide check.. never had a problem.

[AHung]

What brand remote do you use?