my mag somaetimes shoots out 3 balls at a time. how can i fix this?
-
-
on/off pin problem most likely. ellaborate on your setup. -
68 classic warp feed, revy hopper, dye barrel, 72/3k tank, maxflow reg, air valve. and what is the onn/off pin?Comment
-
Is it shooting 3 times for every pull
or
Is it shooting once, and 3 balls come out.
If the first, don miguel is prob right and ignore me.
If it is the second, the ball detent needs some help. It may not be strong enough and the warp is over feeding it.Comment
-
it not doing it on every pull. about every 2 or 3 puls but its 3 balls one pullComment
-
Then its your ball detent.Originally posted by PhantomStalker
twist lock or ule body?Comment
-
its a twistlock. the detents are the same as nubbins right?Comment
-
Detent/NubbinComment
-
ok thanks guysComment
-
Detent for sure...Comment
-
Your velocity could be way too high, that is if the gun fires 3 consecutive times, this happened to me a while back.Il n'y a point de sots si incommodes que ceux qui ont de l'esprit.Comment
-
it was the detent i got it fixedComment
-
Ok, well that's good, i just realized that it might've been the same thing that happened to me.Originally posted by PhantomStalkerIl n'y a point de sots si incommodes que ceux qui ont de l'esprit.Comment
-
be sure to have a couple extra nubbins in your gear bag just in case you run into this again b/c the warp (i imagine) needs a pretty strong/fresh detent to provide the right kind of resistance... also if you have extras then you can be that guy who helps out a fellow mag owner in their time of need... and make a little dough off of a cheap piece of plastic.
i had a similiar problem in one of my guns but it was with a halo... all forcefeed hoppers need a proper detent...
i'm thinkin double detents doesn't sound all that bad for my ule body... hmmmmm. fyi some of the older twistlock barrels actually had slots for two nubbins. i think i had a black alluminum dye that had that once... might be something to check out...Comment
Comment