Is there such a thing? I know that Lucky makes a screw together type for the Ion, but does anyone do it for the mag? It was hard enough getting the pin out of my RPG UL Pro w/ 07 Viperblade, I don't want to try to put it back in. Can anyone give me any leads?
-
-
Any pin that has an OD of 1/8" and a length of 1/2" will work just fine in an AGD frame.Originally posted by LFD92
If the trigger had a bearing in it, you may have to drive the pin through anyway though.
IIRC the lucky pins screw in half and are slightly under size so it will slide into a bearing trigger without having to press or beat it into place.
Unfortunately when you do this, you remove much of the reason for the bearing being there in the first place, since any reduction in slop is reintroduced by the loose fitting pin.
IMO the whole point of having a bearing in there is so that you can have a very tight trigger to pin and pin to frame fit, and still have a slick/smooth trigger pivoting action.
If you use an undersized pin, you negate that effect totally.
But it's your marker, do with it as you please. It won't tear anything up or anything like that, the trigger just might feel a little sloppier. You can always go back to the press fit pin if you don't like the lucky.
Ryan Shanks
Logic Industries LLC -
^^
I understand the size issues with the Lucky pin. I didn't say I was going to get one for my mag. I had one for my Ion and I just knew that was a set up that made sense. Thanks though!
Does anyone know of one for a mag frame?Comment
Comment