would this work>?

[FARMER00]

not very good with electronics so,

http://www.thesourcecc.com/estore/Product.aspx?language=en-CA&catalog=Online&category=Switches+Switches&product=2750016

i know it says 250vac (im assuming it means 250 ac volts) but would it work with a 9v battery that is dc?

[punkncat]

not very good with electronics so,

http://www.thesourcecc.com/estore/Product.aspx?language=en-CA&catalog=Online&category=Switches+Switches&product=2750016

i know it says 250vac (im assuming it means 250 ac volts) but would it work with a 9v battery that is dc?

It means it would take that much load before failing, not that it has to have it.

[FARMER00]

It means it would take that much load before failing, not that it has to have it.

so it will work?

[Thanna]

I think it will, but I'm not an expert on it.

[p8ntbal4me]

Are you looking for a replacement trigger switch???

If so,... you can look up on Digikey for "Omron" switches.

Most guns now adays run 25g switches in them due to the reverse polarity magnet setup in the trigger frames. If you do not have magnets or a spring return system,.. I would stick with a 30-50g switch. (not that you cant use a 25g, but holding the marker in possitions other than horizontal and down will reduce your ROF greatly.)

I use "D2" series switches in most of my guns if I replace them.

The "D2F-L" is the 25g switch that is most common among Smart Parts, ICD, and, Kingman Markers.

[FARMER00]

no, im just having some mental brain thingys going on, im gonna have a few more questions soon, but those will be in the workshop

[commrad]

yes it will work with a 9V battery but it is rated at 250V max