Pneumag question

[hmudd13]

I'm just curious about the routing of the low pressure hose, when you mount the LPR on the forgrip. Do you have to mill the rail?

[olinar]

you sure do. this technique also allows for the cleanest install because there are no exposed hoses. you will need a small channel running for just behind the sear area to the front of the rail.

[hmudd13]

Thanks, that's what I thought.

[Smoothice]

Thanks, that's what I thought.

My pneumag has the hose run inside the rail.

I drilled a hole through the rail.

It required a long drill bit but is very clean and I don't have to worry about my hose coming out of the channel when cleaning.

[hmudd13]

hmmm, that's sounds do-able too.
thanks.