the battery wire was pulled off on the wrap feed. now i dont know where to solder them on and which one is positive/negative terminals. can someone please take a picture of their board and post it here? thanks in advance
-
-
Resolution isn't the greatest, but it's enough to see where it goes. Look to page 1 and 10. -
You may aswell solder the other wire too...even the other ends of the wire where the 9v battery attaches.
The one big flaw with the warp is the soldering for the battery wires. I had to resolder 3 of the 4 connections so far with mine.Comment
Comment