Hey fellas. Can the feedneck on the ULE mainbodies be changed out for longer or shorter feednecks??
-
-
Not to ask a dumb question but what would I be looking for if I wanted to replace a stock feedneck? I understand that when looking for an aftermarket barrel for a mag (not a twistlock) I look for a barrel with autococker threading. I looked up "autococker clamping feedneck" on yahoo and found some but they did not look threaded on the end. Thanks for the help. -
Originally posted by FIST2CUFF
the feednecks on ULE bodies are Angel threaded. same as the Detents.Comment
-
I got a low rise locking feedneck from redz it is angel thread like posted. My fedneck is a lot lower now and I am happy with itComment
-
Thanks for the info guys!Comment
-
Here is a picture to give you an idea how low it is -
Comment
-
i have a ccm neck on mine. i have the "no rise" which will fit the full neck of a halo (or any other hopper with out cutting) and not raise it up at all.
if you are interested the ccm necks and are unser about the heights of them to goes (from highest to lowest) mid rise, mid pro, no rise, no pro.
the "pros" you need to cut ur hopper's neck to fit.
what are you looking to do or are you just experimenting?
-mattComment
-
Information. Thanks for the examples!Comment
-
The feednecks on the Tac mainbodies also unscrew correct?Comment
-
yep yep.
for some reason i remember something about on the tac bodies a feed neck didnt screw in all the way but dont go by me for that, maybe im confusing some other gun (wouldnt surprise me if i was)
-mattComment
-
Then do you rely on loctite to hold the feedneck if it doesnt screww in all the way?Comment
Comment