Missing On/Off part?

[WalkingTarget]

I'm hesitant to say i'm missing an on/off part as what i have doesn't look like a regular On/Off (from what i can tell.....)




I *am* missing an on/off top right?



the odd part, it shot when i gassed it up before..

[Jaan]

It looks like what was an aftermarket on/off called a "Reactor Valve". The older on/off tops were a bit restrictive and this was a better flowing one. I had one and it worked better than my original on/off and then I sent my 'Mag in to be upgraded and they put in a newer factory one that was nicer.

So yeah, that's it. Just an aftermarket part.

[Madmarx]

I think you're missing a piece.
I'll take a pic of mine in a few and post it.

[WalkingTarget]

huh... without that specific bottom, it's kinda useless.

guess i'm off to buy an AGD stock part

[Tunaman]

Those valves caused more problems that any other. Nothing beats the stock AGD on/off valve.

[WalkingTarget]

already e-mailed you about the assembly

i know where to go to get my AGD goodness

[commrad]

i have never had problem with mine and if you need the size of the bottom i can measure mine for you if you want.

[Madmarx]

You can buy my on/off if you want it.
Pm me a reasonable offer.
Then you can have spare parts.

[WalkingTarget]

can i get the measurements on the on/off bottom please? also if it has a groove for an o-ring on the outside?

[commrad]

It is a flat disk, slight bevel on the edges to prevent em from being sharp. It measures 9.5 OD
2.75 thick and 3.06 ID hole (mm)

.375 OD, .108 thick and .120 ID hole (inch)

it is just a flat disk, there are no grooves for o rings or anything, you could easily make one from 9.5mm drill rod.

I never had problems out of mine, some say they aren't any good but I never had a problem out of mine.

[WalkingTarget]

thanks much

[commrad]

If you have a spare on/off top laying around. I'll trade you the entire reactor on/off for it if it's one of the newer ones, I have a hyper frame on/off that I need a top for.