I have a deal on a polished v-feed emag and there is one small problem. He said the top trigger magnet is loose and the gun wont work with it like that. I wanted to know if this was easy to fix? Could I just use some epoxy to hold the magnet in there? Thanks
-
D . Y . N . A . S . T ... Y!
iR3 -
Yes,it's an easy fix.JB weld or some other 15 min epoxy
will work fine.E-Mag #00511 (12in Dye Alum)
Clear Warp
68/3000 AGD Flatline
12V Rev-
Minimag
9v Rev
68/3000 pre-set -
probably much better to use a small bit of double sided tape so that you can remove the magnet, should there be any reason to later.Comment
Comment