Hi, I think this belongs here, but if not I am sorry. I am wondering how you can mount an angel grip frame on a mag rail/body. Thank you for your input.
angel frame
Collapse
X
-
Tags: None
-
I should fit with minimal modification, however, depending what you want to do with it it may not be suitable.Originally posted by GhostWalkerHi, I think this belongs here, but if not I am sorry. I am wondering how you can mount an angel grip frame on a mag rail/body. Thank you for your input. -
-
Look at the Chimera 90 deg. frame from Tunamart.comOriginally posted by GhostWalkerI just want a mech trigger, with the angel frame.Comment
-
sorry to thread jack if thats what i'm doing but couldn't you very easily make a pnue-mag like that?Comment
-
Originally posted by hmudd13What type of modifications? I'm looking to Pneu mag it.
Well, the screw holes may, no may ot line up. Im not sure how close they are cus' I never checked.
Secondly, the problem with using an angel frame for a p-mag is that under the grip frame there is a big empty space on one side where you would mount the actuator. Unless you can figure out a way to overcome that then its probably not a good choice.Comment
-
Thanks for the info, I'd never seen an angel frame bare.Originally posted by BigEvilWell, the screw holes may, no may ot line up. Im not sure how close they are cus' I never checked.
Secondly, the problem with using an angel frame for a p-mag is that under the grip frame there is a big empty space on one side where you would mount the actuator. Unless you can figure out a way to overcome that then its probably not a good choice.
Comment
-
Are you looking into something like this? It's on PBN under AGDComment



Comment