New to the emag. Velocity creeping

[spwz99]

I'm running an Emag valve with a lvl 10 (on the gun when i bought it, so not tuned by me, but works ok) and when I let the gun sit for a few minutes between shots, my velocity creeps up about 20 or 30 fps. I know on a classic valve that means to change the reg seat, but I'm new to Emag valves so my question is: what o-ring should I target in my Emag valve to fix the velocity creep?

Thanks,
Steve

[Tao]

I'm running an Emag valve with a lvl 10 (on the gun when i bought it, so not tuned by me, but works ok) and when I let the gun sit for a few minutes between shots, my velocity creeps up about 20 or 30 fps. I know on a classic valve that means to change the reg seat, but I'm new to Emag valves so my question is: what o-ring should I target in my Emag valve to fix the velocity creep?

Thanks,
Steve

It could be creeping if you have a low pressure going into the valve 600-650psi ish.....http://www.airgun.com/downloads/RT-U...One.Manual.pdf see page 10, 11 to see what I mean (especially top illustration on page 11).

Just one possibility....

[A-Tach-One]

I have had the velocity creep in a couple valves and it was do to debris in the reg. Try stripping it down, completely clean and oil. See if that helps.

[spwz99]

Tao, I don't think it's low input pressure, as I just put a new geurrilla reg on my tank which is supposed to have an output of 850-900 psi.

[olinar]

definitely clean the enitre valve. it should work perfect after

[athomas]

Definately give the valve a good cleaning. Then if it is still leaking, change the regulator seat oring. The valve diagrams are available at the airgun.com site.