Do you need a ULT to make emags work in electronic mode?
-
stay proud, Stay mechanical!
And my feed back is at: http://www.automags.org/forums/showthread.php?p=1771790#post1771790 -
No, you need an EMAG on/off..
an ULT will not work because it doesnt have the force to reset the solenoid.
www.tunamart.com will have the on/off you need. -
Will this on/off work in a Emicromag body also?stay proud, Stay mechanical!
And my feed back is at: http://www.automags.org/forums/showthread.php?p=1771790#post1771790Comment
-
Yes the on/off should work because the valves are the same just different engraving... at least as far as I know... A stock RT or emag on/off should work I thinkComment
-
I thought that the measurements were off without the use of the rail in the MicroEmagstay proud, Stay mechanical!
And my feed back is at: http://www.automags.org/forums/showthread.php?p=1771790#post1771790Comment
-
The on/off pin would probably have a different measurement, but the on/off body and orings of an Emag on/off will be the same.Comment
-
The on-off assembly of the micro-emag is the same as a regular emag, except that the micro-emag pin length is only .685" instead of .712" of the standard emag. ULT kits aren't to be used in an emag.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
RGR, thanks for the heads up.stay proud, Stay mechanical!
And my feed back is at: http://www.automags.org/forums/showthread.php?p=1771790#post1771790Comment
Comment