Draxxus Pulse Help?

[Pigpen]

I know this an AGD help thread but I just picked one of these up used and it just came with a speed loader collar. I need a lid for scenario play and with Draxxus being in a lawsuit there doesn't seem to be parts available.


My other problem is that I need the lid by tomorrow! Is their another lid that will fit, even if it's too large?

I can jury rig something to hold it down for now.

Thanks for any help!

Pigpen
out

[d4m4don3]

I know this an AGD help thread but I just picked one of these up used and it just came with a speed loader collar. I need a lid for scenario play and with Draxxus being in a lawsuit there doesn't seem to be parts available.


My other problem is that I need the lid by tomorrow! Is their another lid that will fit, even if it's too large?

I can jury rig something to hold it down for now.

Thanks for any help!

Pigpen
out

IDK but since the halo speed feed fits on the dxs pulse, you might want to try putting a halo lid on that bad boy.

[Tao]

IDK but since the halo speed feed fits on the dxs pulse, you might want to try putting a halo lid on that bad boy.

If that doesn't work tri the traditional fix...lots of tape

[blake20]

Got my e-mag cheaper!!!

Pigpen, Drop Zone says your screwd. I say try and lid off a pringles can or even a small coffee can plastic lid. you'll still have to tape it but at least you can open it another fix is cut the ring out of the center of a 5 gallon bucket bottom, it would be a little stiffer and it has a rim on it that might fit arround. other than that I agree with Drop Zone

[Pigpen]

The Halo lid worked excellent. Had to cut down the pin length but was actually a BETTER fit than the original pulse lid.

Pigpen
out