ULE Body on RT Classic

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • JH_
    Registered User
    • Dec 2006
    • 287
    #1

    ULE Body on RT Classic

    Can it be done without mods?
    Tags: None
    • Badger1099
      Farmland Paintball Club
      • May 2005
      • 250
      #2
      I do not think so. The only way I have seen this done is by milling the rail for the valve guide pin, and mill out for the ULE(Luke does this). This ruins the gas-thu capability of the rail. It might be cleaner to find a RT Pro rail. I know some of them accept ULE bodies.

        Comment

        • Walrus
          X-Mag baby!!
          • Jan 2005
          • 317
          #3
          Also the valve is smaller in diameter on a RT classic, so it wouldn't fit properly on the rail without the stock body covering the valve. You could create a cover for the valve that has the same thickness of the body to accomodate this. As far as the rail goes...the twistlock pin would have to be removed and the screw hole for the ULE body would have to be milled into the rail to accomodate the body (maybe not, but I haven't seen a classic RT rail in a while to determine this). It honestly sounds like too much work.

            Comment

            Previous template Next
            Working...