Emag Intellifeed cable w/Warp ... Help Please

[2000Sabre]

I need some help. I have a SFL EMag and am using the Emag Intellilink cable to my Warp so it will spin with each trigger pull. However, when I plug the intellilink cable into the Warp, the Warp will just spin continuosly. I have tried turning the Warp's sensitivity adjustment down but this doesn't help. Also, all of the dwell jumpers are installed. What am I missing? Do I need to remove some jumpers somewhere on the Warp?

Any and all help is appreciated. Thanks.

[Russ]

Are your trigger magnets properly set? (i.e. does the gun fire OK?)

Do you have the interlink plugged into the proper port?
It's the one near where the hall effects sensore plugs in, about mid-way on the circuit board.

Good luck

[2000Sabre]

The intellilink cable is plug into the board in the correct location. The gun fires fine so the magnets should not be part of the problem. I'm using the factory setup and have not messed with the trigger at all. The only other note is that my saftey is messed up and is stuck on but that should not be causing this.

[alf]

2000,

how about the +, -, sens jumpers?

i talked to blackvcg about this, and he said the jumpers should be on the lower two pins...i THINK thats + and sens...but, i dont have my emag with me to verify...

[2000Sabre]

I've got it working now. Apparently, I had the jumpers setup incorrectly. To make this work, I removed the three jumpers located near the primer button, and then reinstalled just one jumper in the middle set of pins. Works great now. Thanks for the help.

[tjussery]

Safety Stuck On

I had the same problem with my safety stuck on. I had to go file the hole where the saftey pin goes through, it had a small burr on the side of the hole preventing the safety from sliding. Take it apart & look at the hole for burrs, but be careful not to loose the small ball or spring that works the safety position. Hope that helps with your safety problem!