AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
I can't figure out how to get the regulator piston assembly out of my valve. it seems to just spin and spin and never move... I'm not sure what I am doing wrong. Advice?
It doesn't thread in.
It just slides in.
You can lightly tap the reg on a piece of soft wood to dislodge it or take a smaller allen wrench and drag it out or use a real small allen wrench and push it out from the other end.
Comment