XValve on/off pin

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • sTaLa
    Registered User
    • Mar 2006
    • 333
    #1

    XValve on/off pin

    Ok, I currently have a pneumag/XValve and broke my on/off pin. I'm using a .712" pin but would like to go back to the standard pin. BlackVSG's thread says I need a .750" pin, but there is no such pin on airgun.com: it jumps from .745" to .755"!

    I sent an e-mail to airgun two weeks ago but didn't receive any answer...

    What on/off pin should I use with my setup?

    Thanks,
    Alex
    Tags: None
    • Russ
      Senior Membrane
      • Jul 2001
      • 1935
      #2
      Hmm, they must be out of them. I bought a .750 a couple months back...

      I'd go with the .755" and trim it down. A file works well, just break the burr with some fine (400 or so) emery paper.

        Comment

        • athomas
          Of course it works-its AGD
          • Jan 2002
          • 8039
          #3
          There should be .750". That is the standard on-off pin.
          Except for the Automag in front, its usually the man behind the equipment that counts.

            Comment

            • sTaLa
              Registered User
              • Mar 2006
              • 333
              #4
              I just rewrote to AGD and the answered me that time. I don't know why buy the standard one was not listed. They just listed on their web site and thanked me to have pointed that.

              So my problem is solved and I just ordered some of them.

                Comment

                Previous template Next
                Working...