leak question

[dizzle]

would the on/off pin being upside down in a minimag valve cause it to leak between shots?

[Russ]

well turn it over and find out!


(answer, yes)

[dizzle]

lol,yeah i did before i posted this but in the same instance i also changed out the power tube tip and the bolt.......just trying to make sure what fixed it....no need to get smart,gosh lmao j/k

[athomas]

The flat end of the on-off pin goes towards the inside of the valve. The rounded end sticks out. If the pin was in backwards, it wouldn't shut the air off between the regualtor adn the front chamber. That would hold the bolt slightly forward and allow air to continually push past the bolt stem and oring.

[dizzle]

yeah te part of the pin that is notched was down(towards the sear)....i flipped it around and it stopped