Got the bug again

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • tea1sugar
    Registered User
    • Jun 2007
    • 3
    #1

    Got the bug again

    Just played today after a long time and got the bug again.
    Want to know since gun design has evolved alot what or how to update my automag level7 to air and what other mods are available for my classic gun,
    Tags: None
    • Coralis
      Hyper Micro
      • Aug 2005
      • 1285
      #2
      Upgrades to consider:

      HPA .... get a preset tank outputting ~800 pounds and you wont need to change a thing ... might want a asa with on/off valve. (degas option is very nice)

      Level 10 bolt ... anti chop bolt not to difficult of an install, might need a new regulator piston.

      Xvalve ... drop in valve with higher recharge rate includes level 10

      ULE body .... aluminum body with vertical feed , Tac one body ... aluminum body set up with extra rails for scenario/woods play

      it really depends on how much you want to spend .... you could probably buy a new gun cheaper than doing more than one or two upgrades at one time.

        Comment

        • tea1sugar
          Registered User
          • Jun 2007
          • 3
          #3
          Got Bug

          Thanks for the info.

          What is required to retro-fit level 10 bolt and convert to air instead of Co2 since it has been 10 yrs since I had played and understood the equipment can someone explain in laymons terms the process.

          I am not familiar with your abbreviated terms for parts of the gun.


          Much appreciated for your time.

            Comment

            • StygShore
              Waterford, MI

              • Aug 2002
              • 2854
              #4
              Pretty simple really.


              Buy a fixed output High Pressure Screw in Air System, Crossfire, DXS, CP Products,Pure energy, Nitro duck, and many others out there now.

              You can use the HPA in place of the CO2 direct, without any changes.

              Level 10 is a direct drop in, you take your Lvl 7 powertube tip and guts out and install the Lvl 10 kit - little bit of tuning based on in the video and instructions, and no more chops!


              Styg



              Sometimes if a gun is old enough it will require a new Piston for the back of your AIR valve to handle the HPA system.
              Sometimes It's Good to be EVIL

                Comment

                • 93civiccpe
                  Registered User
                  • Feb 2005
                  • 572
                  #5
                  Just a note, if you are purchasing a lvl-10 bolt kit from AGD, I would also pick up a valve rebuild kit for it to be safe. Sometimes those o-rings get old and hard if you haven't used them in a while. Plus it's always good to have backup parts.

                    Comment

                    • tea1sugar
                      Registered User
                      • Jun 2007
                      • 3
                      #6
                      Got the bug again

                      Thanks guys for info

                      No doubt will be pestering you guys for more info when parts are ordered and trying to assemble.

                        Comment

                        Previous template Next
                        Working...