Help!

[~W.!.C.K.E.D~]

Just got my new mag, but it won't shoot. X Valve and level 10, no ULT. I pull the trigger, and there is resistance, because its gassed up, but it doesn't trip the sear. What do i do?

[athomas]

Turn up the velocity until it shoots.

[chairman_mao]

If that doesn't work loosen the field strip screw 1/8 to 1/4 turn.

[~W.!.C.K.E.D~]

http://s19.photobucket.com/albums/b192/treystetson/?action=view&current=MOV05217.flv

Neither work :/

[Coralis]

From your video it looks like the trigger rod might be too long ....when the mark is gassed up is there a gap between the trigger rod and the back of the trigger ?

[~W.!.C.K.E.D~]

i've tried it long, short, and with/without a gap...


when i screw in the velocity, how far should it be? I've turned it to the point where it basically stops screwing in...

[flyingpootang]

Are you using a high output tank with at least 1000psi in it?

[~W.!.C.K.E.D~]

yes

[mostpeople]

I would reccomend maybe taking the grip panels off and making sure the sear is going all the way up, perhaps trying to push it farther if it isnt.

Also looking at your vid, your velocity adjustor is WAY out, screw that thing in so its sticking out half as much as it is now.

[pierce]

Try the shortest spring. Carrier might be too small.

[~W.!.C.K.E.D~]

^ I've screwed it is as far as it will go, and tried 3 different springs

[Badmovies.org]

Is that *POP* it firing once when you gas it up?

I wonder if you are getting bolt stick. Have you tuned the Lvl 10?

Oil your o-ring, put it into the 2.0 carrier (2 lines, no dots), slide it onto the bolt stem and attempt to dangle the bolt (you are holding the carrier while trying this). If the bolt slips off the carrier from its own weight, go to a smaller carrier. Use the largest carrier that will not allow the bolt to slip off using this test. Do not add any shims yet. Oil everything, assemble, and break in the o-ring by shooting out a tank of air. After doing this, you may need to change carriers and use the next smallest. Now, start adding shims one at a time until it leaks down the barrel. Take a shim out. You are ready to go.

[~W.!.C.K.E.D~]

Yes, the POP is fireing on gas-up, or the 1st time i pull the trigger.


I tried your idea, and the 1.5 carrier fits best, but still not shooting...

[Badmovies.org]

I think that you said you had played with the length of the trigger rod? Set that back to the original length, it will not quite touch the back of the trigger when gassed. Also, put in the red spring and turn up the velocity.

[TnDeathInc]

Same thing happend after i bought lfd's olive mag it would fire once then nothing.

Take a hard squeegee and push back on the bolt to reset it. if it fires a gain and hangs, you can try


lvl x carrier, or u need a stiffer spring to reset the level x