stuck

[bigboyhutch]

i have a minimag and for some reason it keeps sticking. I know its not the trigger but it has to do with the air or valve I currently run HPA through it and i have oiled it twice thinking i missed something. i do only have 1000 a little under psi in the tank. but heres the deal.

I had it working yesterday shot about 200 rds and went great no ball break and for the most part accurate.

so i wake up this mouring to play and shoot like 30 or so balls and then stoped. the trigger felt compressed

so i stoped took it apart lubed it checked everthing was working smooth. so put it back together aired up w/ the 1000 or so psi left in tank and shot like 100 balls and then kaput!!! Samething!?!? so any suggestions?

could it be bolt, spring??? air pressure???

[Russ]

download the manual from the airgun design website...

...read it, and troubleshoot your issue(s)

[bigboyhutch]

download the manual from the airgun design website...

...read it, and troubleshoot your issue(s)

been there done that cant seem to figure it out does anyone have any input torwards what i might do?

[bigboyhutch]

been there done that cant seem to figure it out does anyone have any input torwards what i might do?

having moisture dosent help

[Badmovies.org]

Tank regs are not always accurate. I would get the tank filled, bring the marker with you, and check it at the paintball shop.

You may need to replace your bolt spring. That is always a simple, inexpensive fix for older AGD markers.

Do you have a Lvl 10 bolt in it or a Lvl 7?

[athomas]

It is quite possible that the output from the tank is low due to low tank pressure. The gauges are inaccurate, especially on the low end, plus the tank reg is further reducing it even if the output is set to a value equal to or higher than the pressure in the tank.

Once you get the tank filled, you can properly test.

Are you using a level 7 or level 10 bolt?