Has anyone used the extra gas ports on a classic RT rail for the LPR on a pneumag conversion? It looks like it could make some interesting setups. Kind of large, but interesting.
-
-
It's been done.
Saw pictures of one with a z grip on it with the lpr on the rail. Not completed, but looked to finish out very cool. -
gas ports on a a rail?
can someone post these pics...Comment
-
The standard ports on the classic RT rail. I think there are six (three on each side below the valve). That's why they have the banjo bolt for a rear frame screw. The ports were for future 'accessories'. Maybe there are some pics on the airgun.com site.
Is the pull in a classic RT on/off the same as the newer RT on/off? Classic RTs seem to get lower prices (for a good reason I think). They might make good project guns. I had forgotten about all those ports to play with.
Here's the pic...
Classic RTLast edited by Spider-TW; 07-27-2007, 09:00 AM.Comment
-
if i had an intelli for my classic r/t it be pneumag'd by now. though i need a new rail because someone who had the gun beforem me striped every port hole
. as far the the trigger pull goes id have to say it more than likely the same givin the same length pin. different pins will produce different feels. good luck with your project, pneumag kits are back in stock here so all you need is a frame to mount everyhting in.
Comment
Comment