Slug details

[punkrex]

Hello, I have been reviewing the slug drawings and have a couple questions:

First, the drawing doesnt specify the the barrel threads. I imagine they are Cocker threads but what threads are they?

Second. When looking at detail A, I see there is a spring clip and retainer cutout...
can someone elaborate cause all I have is a mini and there is no such structure, just a welded fender washer...



Detail more detail of detail


Thanks

[Dend78]

you are right on the cocker threads but i dont know the exact thread pattern

as far as your other question im not sure on that either i was remaking all of that stuff in 3D and noticed that as well

[Thanna]

There was a recent thread in DocNickel's guild forums where someone posted info about it. Let me see if I can find it.

p.s. Found it

http://www.network54.com/Forum/9013/message/1189130670/Autococker+Threads

[punkrex]

Cool, that resolves the threads , so back to the detail in cutout C...

[RobAGD]

It is basically a SS washer to act as a wear plate. Its harder than the Alumium body, and gives a but more are for things to wack to disapte energy. It also is a good referance point to make sure the bolt depth is correct as well.

-Robert

[punkrex]

It is basically a SS washer to act as a wear plate. Its harder than the Alumium body, and gives a but more are for things to wack to disapte energy. It also is a good referance point to make sure the bolt depth is correct as well.

-Robert

I understand the concept of disapating engery and that all makes sense.
I am really having a hard time visualizing this. There are two groves seperated by a space.

_/ |_/|

The first grove holds the retainer clip... the space is for the washer/wear plate. What purpose does the second groove serve? Does it hold a grommet to cusion the washer?

Would someone clairify or can anyone provide a physical picture?

And Geeze Louise, one would hope the bolt depth is correct with such tight tolorances

[Dend78]

time to fork out the money for one and chop saw it