Anybody doing Pneumag conversions as a service?

[Spider-TW]

If you need any of the drills/taps, let me know. I just finished my own pneumag, and I don't need all the tools anymore. (Pics/prices are in my sale thread.)

Selling tools??? I thought that only happened in estate sales. I thought tools were like markers (and guns, money, ammo), you can't have too many. What a concept...

So, you don't think you will at least be doing another pneumag? The rule of tools says you will need a particular tool soon after you lose it. I don't know if there is a rule about selling them.

[rkjunior303]

you might wanna look for a macdev lpr.. they are the smallest cocker lpr i believe.

[psychowarden]

Yeah, I've been looking for a Macdev reg for a while, and havn't found one yet. I'm probably gonna go with a Palmers Micro - Rock.

And I have a full set of taps Gift from my grandfather.

[Ruler_Mark]

theres one on pbn im too lazy to get the link.

[psychowarden]

Has anyone done a Pneumag conversion on a Y-frame yet? I didn't figure it would be much different, as long as the insides are the same, just reversed.

[Papa_Smurf]

Has anyone done a Pneumag conversion on a Y-frame yet? I didn't figure it would be much different, as long as the insides are the same, just reversed.

I have. Then again, I have a mill.

[psychowarden]

I have a dremel...

Could you post pics of the inside of it?

[Papa_Smurf]

hahaha. Big step between.


All I did was remove the "bar" across the middle. I used a keyway cutter to take meat off the sides, but that wasn't needed to do the job, just to make it lighter.

[Lomarandil]

Oh PapaSmurf ... any chance you can give me a reason to smile?

[Papa_Smurf]

Oh PapaSmurf ... any chance you can give me a reason to smile?

everything is in but the ram. I broke a case hardened steel tap into two so I have to get another. After I drill and tap 4 holes it's headed your way.

[Lomarandil]

Dang skippy, was it that blasted anno again? Well, nearly done anyways!

On topic, if you change your mind about doing it yourself, I have to say that so far PapaSmurf has been great! I'll make sure and put up pictures once it's done too.

[Papa_Smurf]

Dang skippy, was it that blasted anno again? Well, nearly done anyways!

On topic, if you change your mind about doing it yourself, I have to say that so far PapaSmurf has been great! I'll make sure and put up pictures once it's done too.

That was no joke. I had to get out the 3ton arbor press out for that one.


Thank you thank you.

[psychowarden]

How much would you be charging for the install if I were to provide the frame and LPR?

[Twistedpsyche]

By some crazy and odd chance, I actually downloaded the vid on accident a few weeks back and held on to it, so I have it

Anyone know where I can find said video??

[BigTrucker]

Heck id would be in the market to buy a frame already done. If one of you guys are up to it PM me and ill give you the cash to build me one.