JT Whippersnapper Goggle Foam and Lens Replacement

[druid]

[druid]

[druid]

[druid]

8. Remove the lower, angled sections from the remaining foam as they will not be needed. They will, however, serve as extra pieces if you feel the need to add to any area of the frame.

Trim the end of where you just cut this foam so it will fit what is already glued on the cheek-plate. Begin gluing from this point and up to the brow-line and STOP. Do the same to the other side.

9. Lay the foam to the center of the lens and trim each side two that they meet in the center. I used the center post hole for the visor as my center guide. Glue in place.


Here is the finished foam installation:

[druid]

[Sumthinwicked]

nice im the same way about mine but mine has a pressure crack in the grill i might grab the new airsoft one at walmart and move the grill over