Micromag questions

[jonnygros]

Hello all! i was planning on making a micromag and had some questions i was hoping you could help me with.

1) Can a level 10 kit fit into a micromag body without modification?

2) I have a hyperframe i was wanting to use but it has had its wings milled off, will this be a problem? if so is there any way to get past it?

3) Will the level 10 sear fit into the micromag? or will i need a different kind of sear?

thanks for tolerating my questions as they might seem kind of newbish, keep in mind i'm green to the world of mags.

Jonny

[Viffer]

1) Can a level 10 kit fit into a micromag body without modification?

Yes

2) I have a hyperframe i was wanting to use but it has had its wings milled off, will this be a problem? if so is there any way to get past it?

No problem

3) Will the level 10 sear fit into the micromag? or will i need a different kind of sear?

Level 10 sear??
You need the micromag body sear.

[Sumthinwicked]

wings wouold have been better for #2 but you can have a pin tapped into the body and screw in a rt pro sear pin into it the wings actually held the mm / am sear pin in and the sear has to be a reg mm am sear hope that helped

[jonnygros]

so i could use my regular automag sear with the hyperframe on a micro body? i might need some more clarification on how to get it to fit.

[Sumthinwicked]

regular sear remove the swivel then you put in the sear pin and put the frame on if you didint have the wings milled off that is .....now you have to get a pin from rtpro JUST THE PIN they are like 4 bux i think tap the hole that the pin slides into and put it all together

[jonnygros]

the sear pin is the part that fits into the large hole in the sear correct? do you know what size tap i would need to use?

[Sumthinwicked]

no sorry that i dont know i have had a sear made to fit the hole at work long time ago and it was a stepped funny looking item but it worked so i know it can be done and i have heard of the rt pro sear mod done on here many times