[No Subject]

[Pneumagger]

[Toll]

Dear sir;

I echo your manic laughter.

[Ruler_Mark]

mpsd's?

[Pneumagger]

Yup. It's en route as I type.

[Mwahaha MWAHAHAHAaaaaa!!! ]

[Ruler_Mark]

mmm very nice, now when are you going to offer this.

[p8ntbal4me]

Nice.

I went (im pretty sure) the same route you did with your micro switch mounting.

Spent some time to come up with a design that allows for no holes on the sides of the frame.

~ P8nt

[Pneumagger]

The trigger pins screw in from the right side. There is a long 4-40 screw turnde down to the right ID and only the very and has threads. I find it allows for the most secure install yet easiest access if needed.

It looks exactly like an RTP sear pin, except smaller.

[p8ntbal4me]

The trigger pins screw in from the right side. There is a long 4-40 screw turnde down to the right ID and only the very and has threads. I find it allows for the most secure install yet easiest access if needed.

It looks exactly like an RTP sear pin, except smaller.

Ahh,.. okay.

Yeah,.. my trigger setup is different.

Your milling for the solenoid looks WAY cleaner than mine though. PM me if you wanna trade secrets

~ P8nt

[Heiliger Bimbam]

Really nice.

Looks like a T-Board. I'm converting a Mag into a T-Board-eMag, too (merely with a Festo EP-Noid). Hope it will do the trick.

[Dirge]

Very nice craftsmanship! Looks factory.

What kind of solenoid is that? It looks a bit smaller than the usual 1" ones usually available.

[Automagrt666]

My god, must... before it...

This is exactly what I was going to do to my upcoming Karta, I would love specs of the junk in that trunk used! Incredible sir! I can't wait to see a video of it

[p8ntbal4me]

I keep looking at this,..and it gets me all curious on the way you did some of the work.

Those grip pannel holes look like DM3 grips,... but I was thinking the older Angel LCD grips would be a better fit. What did you end up going with?

~ P8nt

[Pneumagger]

WGP Eblade grips (or Etek Ego), approximately. They had the best fit to the frame of any plausible commercial hole pattern.
The top two holes fit the grip holes and I drilled the bottom screw hole off-location so it could have more frame metal to tap into solidly.
I'll just put a new hole in the grips to fit the frame hole.

The nice thing about using Eblade grips is that are already designed to house a pancake solenoid.

[robnix]

Fantastic work!

[babyface]

wow looks factory. very nice work