100% sleeper Ygrip pneumag!

[MANN]

The next project on the list. 100% sleeper pneumag. I got the lpr mounted today. going to use a msv-1 probably or maybe a 2 with cut down lever. I have a drill that fits inside the foregrip so there is no need to drill through the front of the foregrip.

Pics so far...

[Swiss Cheeze]

That looks sweeeeet.

[finnmanpa]

What is meant by "sleeper", all the parts are in the grip and not external?

[Pneumagger]

This looks like a good application for one of those MSV-2 lever arms with the rod threaded into it. Then you don't need a hole at all.

Looks Great!

[MANN]

This looks like a good application for one of those MSV-2 lever arms with the rod threaded into it. Then you don't need a hole at all.

Looks Great!

Good call. I will have to see how that lines up.

[MANN]

What is meant by "sleeper", all the parts are in the grip and not external?

correct. there is no way knowing that it is upgraded without removing the grips.

[Pneumagger]

correct. there is no way knowing that it is upgraded without removing the grips.

Or by the fact that it starts ripping 15bps by just staring at the trigger hard enough.

[NoremacTheImpaler]

What do you mean by threading the rod to the lever arm? with out needing a hole? wont the MPA 3 be in the way?

[Pneumagger]

Drill a clearance hole for 4-40 threads into the lever arm. Screw the sear arm into it. Secure the rear of the threads with a dab of JBweld epoxy.
Now there is a trigger rod attached to lever arm and doesn't need a hole. There were 2-3 mags done this way that I've seen pics of in the past.
I'm just too lazy to find them at the moment... and there is a naked female getting out of my shower any minute now

[MournBlade]

Yes the mpa3 sits on the shelf straight, but the front will need milled a little to allow the M3 nipple to pass. It leaves a 3/64 or 1/16 gap where the shelf and the trigger rod rides. A rod could fit through there with a little effort. The msv2 would need installed at an angle so the arm travels straight back to avoid the bottom of the mpa3. The arm will also need shortened to fit with the lpr inside the grip.

[babyface]

Drill a clearance hole for 4-40 threads into the lever arm. Screw the sear arm into it. Secure the rear of the threads with a dab of JBweld epoxy.
Now there is a trigger rod attached to lever arm and doesn't need a hole. There were 2-3 mags done this way that I've seen pics of in the past.
I'm just too lazy to find them at the moment... and there is a naked female getting out of my shower any minute now

when your done doin the nasty, would you be able to post pics im very interested in seeing how its done. (of the internals of the sear arm mod- no pun intended)