Trigger stop frame saver

[flyingpootang]

This is my simple solution to stop the damage to trigger frames caused by the trigger stop vs buying a 3.00 set screw with a nylon insert and the hassle of finding it in the correct size. Though careful thought and a highly intelligent conversation (thus the complexity) with Z-Man we came up with this idea. Reverse the trigger stop in the trigger and insert a proper size piece of o-ring, reinstall the trigger and your done.....

[Ruler_Mark]

adjusting will be a pita

[flyingpootang]

adjusting will be a pita

Not at all It's held in by friction just enough to squeeze in without the worry of coming out. Also every time the trigger is pulled it squishes a bit....

[Spider-TW]

I think RM means how do you turn the screw or adjust the pull length? I've had some screws like that with a deep socket that could be cut, but leaving the front open would let the oring out.

That's a swanky frame and trigger. I see why you're working on a soft stop.

[flyingpootang]

I say get it where you like it and reinstall the frame. I'm kinda finicky with my trigger, but never find the need to adjust it once it set.

[p8ntbal4me]

I say get it where you like it and reinstall the frame. I'm kinda finicky with my trigger, but never find the need to adjust it once it set.

I bought 2 boxes of the screws (50 total) you are talking about for under $20 from McMaster-Carr

I think they are cutting some of the inventory down,.. might wanna check it out!

~ P8nt