So, im picking up a Ul framed mag... hopefully,

[laxmaniac88]

and i want to either ep it or spydermod it. The problem is, i dont think a spydermod will work because the frame is too thin where the noid would have to go. Now, there is also a catch, if I ep mod it I dont want to see the LPR attached to the ASA. I could always mount it out front, but the rail is already custom milled, I dunno if there will be room to do so.

Anyways, what I am really looking for is a good machinist to do this, this mag is way to expensive for me to mess it up. Im just not sure who to talk to, with Ken unable to work for awhile. Heres what I would need:

Either mount the LPR in the frame somehow, along with a board, noid, and Clippard actuator, OR
Mount the Lpr on the front of the gun, run all internal hosing, and still mount everything in the frame.

I dont know who else to look for on this, because this isnt very simple, especially with the clippard probably needing a tray made to mount it.
SO, thanks to those who took the time to read this, do you guys know of a good machinist for this kind of job?




also, for those of you who recognize me from the nation, thanks a ton for helping me set this account up, Im finally up and running.

[p8ntbal4me]

First,.. Welcome to the AO!

Anyways, what I am really looking for is a good machinist to do this, this mag is way to expensive for me to mess it up. Im just not sure who to talk to, with Ken unable to work for awhile. Heres what I would need:

For the machine work,.. look up Matt (user name is "luke") who runs Lukes Customs.
He is a long time member here and does GREAT work for milling! I have had him do a bunch of custom stuff and its all top notch. He has well over 5 pages of 100% feedback.

Either mount the LPR in the frame somehow, along with a board, noid, and Clippard actuator, OR
Mount the Lpr on the front of the gun, run all internal hosing, and still mount everything in the frame.

You need to decide if you can actually get the LPR in the frame. I will say that for installation,.. it can be hard to fit everything inside the frame with an LPR.... impossible,... no. For this route your going to want to talk to Josh (user name "MANN"). He can/has done it a few times. There are pictures of his work on here......

I dont know who else to look for on this, because this isnt very simple, especially with the clippard probably needing a tray made to mount it.

You dont need a tray to mount the clippard actuator (its called an "MPA-3") Talk to Erik (user name "Cyberave68") about getting a complete MPA-3 and some set screws.
You can also ask MANN for these parts as he sells Cyberave68's stuff as well.

You should search threads on "How to Pneumag",.. that will get you a basic setup on concept of half the job done. Then swap out some parts for electronics and your done.

also, for those of you who recognize me from the nation, thanks a ton for helping me set this account up, Im finally up and running.

Your welcome



~ P8nt