Sear mod in progress

[questionful]

Here's my latest project. It's been laying around unfinished (barely started) for a few months, but I've recently become interested in it again. Here's the progress I had finished as of a few months ago, and I still don't know exactly what I'm going to do, but I think it'll turn out fine.

Basically one day I got fed up with having to choose between the ULT's adjustability and the RT's RT. So I decided to combine the two by retrofitting my sear with an adjustable on/off pin contact point.

It's not done. I'm still not sure what I'm going to do. All I've done so far is remove the sear bump, and drill and tap a small hole. Through this hole I'm going to have some sort of adjustable on/off pin contact. It will probably make use of the brass screw you see pictured.

http://i194.photobucket.com/albums/z304/Qful/img_2827.jpg

http://i194.photobucket.com/albums/z304/Qful/img_2827.jpg

http://i194.photobucket.com/albums/z304/Qful/img_2827.jpg

[Spider-TW]

That's nice job on a mean hole.

The brass may be a little soft, but it should do what you want initially.

Are you using it on the ULT, RT or both?

[questionful]

I'm using it with an RT on/off. That way I can adjust the seal point without having to shave my on/off pin to a set (and irreversible) length.

[eXo_oUtSiDeR]

all three pictures are the same

[Looper]

all three pictures are the same

It's a do it yourself picture hunt... I found them at the addresses below...

http://i194.photobucket.com/albums/z304/Qful/img_2826.jpg

http://i194.photobucket.com/albums/z304/Qful/img_2827.jpg

http://i194.photobucket.com/albums/z304/Qful/img_2828.jpg

[questionful]

Yeah sorry about that.

The only progress I've made is flipping the screw upsidedown, flattening the screw head, and finding a small flat steel disc to glue onto the screwhead to increase the radius of the contact surface. Because it turns out I drilled the hole a little off center. So right now it looks like the on/off pin is going to have a hard time making contact with the sear. I hope I explained that well enough for you to visualize it.

But I just found out that my on/off pin is broken. I must have been a dumbass at some point. Anyway, as soon as I get a new on/off pin I'll be doing some tests, mainly just to see if it can work. Besides that I think all I have to do is drill and tap a hole for a set screw to hold the other screw in place.