These are neat. Rounded, button-head grip plate screws. I know they will fit SP grip mounting holes, which are 6-32 x either 3/16" L or 5/16" Long depending on grip panel thickness. So if your grip panels use 6-32 screws to hold them on, they should fit...I might have to pick up a few.
-
These are neat. Rounded, button-head grip plate screws. I know they will fit SP grip mounting holes, which are 6-32 x either 3/16" L or 5/16" Long depending on grip panel thickness. So if your grip panels use 6-32 screws to hold them on, they should fit...I might have to pick up a few. -
what if you have metal side covers?
-
I'm positive these stick outside the grip...metal side covers would probably fall under the 3/16" L category of thickness so at most you might have to grind a little off the length of the screw? I don't know....but if someone needs to access their board/grip internals more often than a semi-guy...it's gotta be a plus......lolComment
-
I'm thinking they go on the frame in the regular screw holes without the grips and you need rubber grips or some other snap mechanism (orings?) in your grip to hold the grips on to the screw heads.
Comment
-
I would assume that all depends on how 'thick' the flat plate part under the ball is....Originally posted by Spider-TWI'm thinking they go on the frame in the regular screw holes without the grips and you need rubber grips or some other snap mechanism (orings?) in your grip to hold the grips on to the screw heads.Comment
Comment