side feed tach one E mag.

[gommie404]

hi there chaps following on from my side feed ions and sp8s..

Heres my X mag .. after having a tac one body and emag rail fitted.

how ever your going to have to follow the link as for some reason this site dont like my piccys.

Dont know why there in the right format and size.. oh well im great with machines but not computers,, any way have a look and see what you think..

sorry for all the camo but its how i play .. lets put it this way my back up weapon is a paintbrush. As i do like to get close..

heres a link ....http://www.ukscenario.com/forum/view...hp?f=11&t=9678

in the words of johny cash , come and see and i saw...

[Bagheera]

Lookin' good! So that's a rip clip, if I read correctly?

[gommie404]

Yep came out a bit bigger than i like..
so at some point soon im going to make my own hopper but using the drive cone from the rip clip. but the cool thing about the set up is it only use,s one single nut and bolt to attach to the side of the tach 1 frame.. if i can find a 90 degree elbow i can still use it in a normal fashion.

But this set up works well .. and with the lv 10 bolt i dont have to worry about putting the ace in.
but some thing i have found is that the drive cone comes up a bit short on its rotation.

So to cure this im going to make the gear wheel on the motor a wee bit bigger.

at first i did one of my side feed halos ,, but its just two fat..
i want a small hopper set up im only looking for it to hold around a 100 balls..

i have a old rip clip shell that been ground down to a much smaller size.
this was fitted to a sp8 with the batterys in the sp8s front magazine and the board in the back of the marker.. only thing is i cant do that with the tach one.

But i may be able to use the tach ones battery if i step down the amps and volts..

will post up as i go along.

[Warwitch]

Very nice setup with the RC.

You might note that its an E-Tac not an X-Mag though. Or were the lowers from an X?


Edit: nvm, guess Im illiterate.

[drewkroeker]

Do you still have an xmag body and breeches kicking around? If so, PM me!

[gommie404]

Ok im having a bit of a swap meet with you chaps.

letting go my Xmag parts for some tach one parts. As im going to build the same thing again
but with my own hopper.

i want to get this much smaller ..and the lv 10 bolts work so well that i not going to bother with the milling for the ace board,,
i may add some eyes at a later date ..

but my first one works so well that in happy with it..
there was a bit of missfeeding but after stepping up the speed of the rip clip it worked out ok.
And the long silencer works very well in soaking up the extra psi blast from the lv 10..

but that will be my next project to bring the working psi done.

but first lets go and play..