I have been looking for a 'how to' for making an intelliframe ready for a cyberave pneu kit. ive looked here, beo, pbl, and mcb with no luck. I have seen pics of the insides of the frame with the kit installed. but i am unsure of what holes to drill where, how the rod sits between the trigger and msv2. I dont have the pneu kit in possession yet, that might answer some questions. but i was wanting to prep the frame. thank you in advance for the info folks!
-
-
You should be able to set up the frame just like is shown on BEO with the chimera. Really the best thing to do is actually have all the parts and lay them out before you start drilling/tapping. Though I suppose you could always drill the hole for the trigger rod. Again, it should be similar to how it's done on the chimera.
Comment