Spyder pump

[211]

a trilogy valve pin/cupseal would get rid of all your blowback

[reckid1986]

i was thinking something like that. i seen the regular cocker valve only has one oring, but ill look at the trilogy set. thanks

[PrimoRocker]

Hey infoyou - AKA makes spyder valves that have no blowback, just perfect for this project

[reckid1986]

where can i find one...

[Frizzle Fry]

where can i find one...

AKA sells them.

[reckid1986]

wow 69 bucks for a valve, looks like ill have to watch b/s/t forums for one, did a search and seen a guy just sold one on pbn for 25. hope i can find a deal like that.

[reckid1986]

does anybody know the purpose for the pin that is behind the valve? i think that is what is causing the "farting" when its fired because the striker bounces off it. would it hurt to take that pin out?

[vf-xx]

Doesn't that pin locate the valve?

[reckid1986]

well i would think the screw under it would keep it in place.

[reckid1986]

well i dunno what to do about the "farting" ive tried different springs, pulled out that pin behind the valve and that just makes the striker hit too hard on the pin/ valve.
I see most of the Kaos pumps have the same problem with farting. So i guess its not that big of a deal. Just not very efficient on 12 grams.
I will be picking up a reg, and a better valve, pin, and cup seal.

I wish my next pneumag parts where finished so I could work on that and just put this on shelf for a little while.