ok i got a free spyder body from a kid at the shop and i mad a gas hog warp thingy. its powerfeed, so i cut down the top of the feed, where the elbo would go on, and i put the plug there. i then drilled a hole in the frame behing the valve, tapped it, and put a male threaded pipe adaptor. i ran macro line out of it. ok this is the warpless wapr part. i took my revy and made a bracket outa an old peice of aluminum with a hole for the revy to slip into. then i ran tubing from an older warp from the bottom of the rev. to the feed tube. with the macro i put a whole in the warp hole and fed it into it facing down. kinda hard to explain. it didnt work too well, i was hopeing to have the air go thru and push the balls up. but o well. it was fun. and looks cool....
Comment