Does anyone know the best way to strip anno off a marker body? I heard oven cleaner works good, any truth to this? How long do I soak it? Or do I scrub it?
-
-
i usally just suck it off.
hehe... eeeh
Get access to a bead blaster.
I dont think oven cleaner would work. -
I think you need nitric acid, but dont quote me on that.:headbang: :headbang: :headbang: Metal kids have more fun!! :headbang: :headbang: :headbang:
Atleast wipers are good for something........target practice.
-=Proud 04 Shocker Owner=-
Comment
-
anno stripping
Lye and water will work. Mix it in a big rubber tub and put it in. Allow it to do its magic and remove.
Im not responcible if u screw up.RM #005
Its so hot I could cook on itComment
-
Lye with water is a fast way but don't leave it in too long or it'll start eating away at the raw aluminum.
There's also hand polishing, which is a lot more time consuming but a lot more controllable.~The Wanderer~Comment
-
Just use some Drano Max, leave it in about 5 mins and then wipe for a minute with some old cloths to get the extran anno off, then repeat 2-3 more times. I actually just did this the other day and it works fine.
My feedback thread
AIM-bertmcmahan
My email:[email protected]
Good traders: richie,Roguefactor,moufo48,845,brtncstm160,vf-xx
Mags don't shoot darts... they shoot nails.
I used to be bertmcmahan, that I did.Comment
-
Good Lord!!! Hand polishing is HARD work and it takes me two shows of the Osbournes (sp)? to finish a 2 inch square. Have fun dude!
N.A.T.O.
Feel The Burn
[AO Feedback]
PBN Feedback
Comment
-
Hand polishing anno off is a mistake. Since the anno is harder than the raw alum under it you will probably end up with pitting. As you get through the layer of anno in one part, as you remove the anno around it you wear more raw alum off. Chemicial stripping is the right choice.Comment
-
Yep bead blasting it will do the same thing. just not as bad.Originally posted by Hexis
Hand polishing anno off is a mistake. Since the anno is harder than the raw alum under it you will probably end up with pitting. As you get through the layer of anno in one part, as you remove the anno around it you wear more raw alum off. Chemicial stripping is the right choice.Comment
-
you can bead blast it if you want a dust finish. If you want the gun smooth dont. Oven cleaner does work I have used it before
Comment
-
Red devil drain cleaner, Works fine.Comment
-
Basically, nitric acid and lye are the same thing, but I've heard about anno coming off and gumming parts, so make sure the body is completely disassembled.If at first you don't succeed, put down the books and smoke some weed!Comment
Comment