I have recently gained access to a machine shop with excellent equipment, and I am going to begin producing parts for paintball markers. I need some ideas. Anything you can think of that you'd like to see made, or have made differently, please post it up here. If it's a good idea, I might produce a few and sell them here on AO.
-
new gat:
black and blue russian legion
black/blue 16in ultralight
68/5K screw in
unimount
revvy -
hehehe.....join me in making stuff. Oddly enough my buddy has asked me to make some car parts that are real easy to produce and sell for like $40 bucks. I am gonna make some bank......
.....To make more stuff...
"Your just a myriad on inner conflict aren't you?"
Good Traders: deathstalker, Der Cockermeister, Target, brtncstm160
Bad Traders: None, yet..........
"I have to think of some creative quote to put here don't I?"
Feed Back:http://www.automags.org/forums/showthread.php?s=&threadid=119588 -
make a dove-tail type of warp connector, eg. you would screw this piece to the gun, the piece would have a small dove-tail on it so that you could slide things on and off. Then the other piece would be the other half of the dovetail connected to the warp, then you would slide the warp on and off the gun really easily so it would be easier to store etc.... als you could have a small lever to make it easier to tighten it together, instead of using an allen key each time.
iv'e been asking people to make this for agesswanster
STORM UK
sponsored by:
Empire
NPS
Diablo
AGD Europe
Air America Europe
MPM
www.stormpaintballteam.comComment
-
good idea, swanster, i'll work on itnew gat:
black and blue russian legion
black/blue 16in ultralight
68/5K screw in
unimount
revvyComment
-
how about a couple of those caps that go in the front half of the regulator on the valve of a mag. that way you can remove the back half of the valve (regulator) and cap it, then use pre regulated air running to the valve to power your mag... its been done, just hard to find pictures...Comment
Comment