warp feed ?'s on a spyder imagine

[paintball_wiz]

yo, whatz up, im new at this kind of stuff, i was told to go here to find answers about my new Warp Feed. Anyways, i wanted to know what's the best way to figure out what speed to set the warp feed to if it's on a Spyder Imagine?

[angelbeast24]

just turn it on the most senistive setting then mount if its to sensitive it wont hurt but if its not then ur goin to not feed balls...if u haev an agd warp feed of course

[Commissar_Loki]

Hmm, I'll help as best I can here. To turn the sensitivity up or down, remove the black plastic cover on the raised part on the side of the warp (right side of it). The should be a white screw, turn it clock-wise to intensivy the sensitivity and counter to turn it down. Turn it clockwise till the motor keeps spinning, then turn it down just enough to make it stop and an extra 1/8 of a turn (roughly). Your warp will eventually work itself a bit and you may have to redo this after a couple of outings. As for mounting, its fairly straight forward for mounting so I'll skip that, if you need help just ask and someone will answer about that. A spyder Imagine I don't remember if it is power feed or vertical feed so I'll talk as if it is Power feed because I'm not sure how to if it is a vertical feedneck. For power feed its simple, attach the hose connector to the warp, and the other connector to the bottom of the power feed, making sure to insert the Warp's powerfeed plug is in the power-feedneck. Then cut the hose to the length, allowing a Cm or less of slop "just in case". Thats how I did it on my power feed mag basically, so I hope I helped. Ans on a side not, Welcome to AO.


-Butch

[DementedChild]

plus the bracket needs to be modified to fit the offset threads on the trigger frame the just take the vibe sense lil bit back from when it just keeps going