I have another new gun idea. It would be single tube. Inside the tube would be a valve, with the back part like a classic valve (regulator). The other part of the valve would have two tubes, one bigger than the other, so that one can slide into the other one. The smaller one would be the bolt and the larger one would be like the on/off. When the trigger is pulled a sear would push the larger tube back ward, making the edge hit a down ward angled prong, which controls the gas release. The bolt would work like an automag bolt using a spring to reset the bolt. The back tube would reset by use of the regulator. When the regulator charges the air would push a small peg that using the recharge air, go through an appropiatly sized hole in the regulator wall and push the large tube back into position.
To recap: When charged A movable peg in the regulator would go through the front regulator wall to reset the back tube. When firing a sear would push the back tube past a prong that would allow gas flow, making the bolt release. A spring would reset the bolt and it would repeat itself.
To recap: When charged A movable peg in the regulator would go through the front regulator wall to reset the back tube. When firing a sear would push the back tube past a prong that would allow gas flow, making the bolt release. A spring would reset the bolt and it would repeat itself.
Comment