Anit-chuff idea...

[AnArchist_1944]

my idea to make it chuff less is......(dont flame me plaese iam new )...... to drill a hole in your trigger like the what you would do for a trigger stop but drill it in the trigger where the sear rod contacts the trigger and install a set screw in there. in theory this should work because the trigger would be contacting the rod earlyer in the stroke therefore minimizing your trigger pull. Used in conjunction with a trigger stop job this could be one short triggered mech mag. providing you set screws are long enough.

let me know what you guys think?

[AnArchist_1944]

is it seriously that bad of an idea?

[personman]

You might as well lengthen the sear rod because a set screw in the trigger would do the exact same thing.. I dont think it would work very well.

[the larch]

Actually, it is a very good idea, and it has been done. Check out logic's triggers and trigger frames. there are two set screws. One that adjusts through the trigger against the sear rod (your idea) and another one lower on the trigger that adjust pull travel.

[AnArchist_1944]

well today i had my trigger setup with 2 trigger stops like bad_dogs trigger stop thread and iam going to see how that works out and if its still not to my likeing then iam drilling a 3rd hole right where the sear rod is and if it works good i post pics and a vid of how it fires

[trains are bad]

The sear rod is already threaded. An extra adjustment would be stupid; it's already adjustable.

[the larch]

The sear rod is already threaded. An extra adjustment would be stupid; it's already adjustable.

No, not really, While it is threaded, you have to disassemble the marker to adjust it. I have a logic frame with the adjustable allen screw in the trigger, and it is well worth it. It REALLY does make a difference, not just hype.