i was doing the 12 volt mod to the warp, i took out the board so i could solder the leads to the board and not just attach the wires to the 9 volt harness like a guy said. well i get the board out, everything is back in, but the warp isn't feeding. it works if i press the primer button, but not if i tap on it. any ideas what's wrong?
-
e-mag 226
flashed with 1.31 -
I bet what happened to me happened to you. You lost the springs that connect the vibration sensor to the board. They're really easy to lose cause I don't think they're in there with anything that pushes them in. I have to use Intellifeed cause I don't have any springs, never had them, might pick some up now that you can get things shipped in just an envelope or something. The link to the springs (they're a lot smaller than they look). They go through a small hole in the shell to the vibration sensor. See if those are there, then repost.
My feedback thread
AIM-bertmcmahan
My email:[email protected]
Good traders: richie,Roguefactor,moufo48,845,brtncstm160,vf-xx
Mags don't shoot darts... they shoot nails.
I used to be bertmcmahan, that I did. -
i have one of them, are there supposed to be 2 of them?
*edit, yeah that was the problem, i lost a spring, but it was found, thx for the helpLast edited by tribalman; 07-17-2004, 05:23 PM.e-mag 226
flashed with 1.31Comment
Comment