I have a few loading system ideas in my head for "the project" and was wondering where i can get a hold of some springs?
I haven't done any measuring yet but it would have to be probably close to 30 inches long (extended), less than a half inch diameter, and will have to be fairly weak as it will have to make a pretty decent bend. (it will need to be compressed down to about a 6 inch space, or as small as i can get it)
I haven't done any measuring yet but it would have to be probably close to 30 inches long (extended), less than a half inch diameter, and will have to be fairly weak as it will have to make a pretty decent bend. (it will need to be compressed down to about a 6 inch space, or as small as i can get it)
Comment