can someone tell me what kind of connector that is used in the emag to warp intellifeed cable. I already have the phone jack and wire left over from making an intellifeed to warp set up for my friend all i need is the piece that goes into the board. Also does anyone know where i can get it?
-
-
http://store.airgun.com/index.cfm?fu...&categoryID=24
It seems to me it's a pretty standard little plug that you could probably find at Radio Shack, although you may have to cut the cordless phone battery off to get the plug 
Knowing the part number would be the main thing, which obviously I don't 
-
its not the same a cordless phone. does anyone know the radio shack part number?Comment
-
You wont find it in any radio shack or store except DigiKey. Its a 1.25mm Molex connector and you need a 200.00 crimper to put it on. I have the ends, crimps and crimpers to do it, but it will cost you less to just buy the emag warp harness. Let me know. Thanks, Tuna
Comment
Comment