I'm wondering, I have a mini morlock and the Hall Effect Sensor for the emag trigger. The the HES has 3 wires, one black, one red and one yellow, how does one hook this up too a morlock board???
Sean
Sean
-
AGD Did someone call me?
You should go to each gun manufacturers forum or call them up. Ask the OWNER of the company why his gun is better. When you get your answers come back here and tell us what they said.
You should buy my gun because I have 5000 posts that say I care.
AGD
---- -
Good question, I remember reading that the morlock supports the HES.
Perhaps you use regulated 5v current from pin 1 on one of the wires? -
Look in this thread for wiring directions: http://www.automags.org/forums/showthread.php?t=118113
The HES works just fine with the morlock
MY TRADER FEEDBACK (<--- click here)
Maroon/Black Karta ULE Emag w/Predator board :)
Red/Black Acid Wash Edge milled ExcaliburComment
-
Hey thanks man! Figures I searched for "HE" and they were saying, "HA" hehehe.
Sean
AGD Did someone call me?
You should go to each gun manufacturers forum or call them up. Ask the OWNER of the company why his gun is better. When you get your answers come back here and tell us what they said.
You should buy my gun because I have 5000 posts that say I care.
AGD
----Comment
Comment