Automag Pistol

[fullofpaint]

Alright I wasn't sure where to post this but here goes:

I'm gonna build an automag pistol but it's going to be different from a sydarm, I'm gonna try and use other parts and uild it for cheaper.

Here's the idea: a classic mag can be picked up for about a hundred, I'm gonna try and get a barebones classic mag with a VA, I'm either going to pick up a ULE body or use an old slug center-feed(if I can find one), Then I'm going to use the smallest possible barrel I can find for it, a 12 gram changer in the VA, and have Punisher or some other custom modder build me a spring-fed tube to go on top.

Here's the part's list:

Classic Valve
Single Trigger frame
Vertical Adapter
Small 8'(or smaller) barrel
ULE body (possibly a slug instead)
12 Gram Adapter
12 Gram Changer(need suggestions as to a good one)
Custom 10 round Spring-Fed tube

That's everything I think I'll need, my question is will it work?

[Big'n slo]

Should work fine

[fullofpaint]

nice, I figured it was kinda obvious and that someone else would have done it, your`unning CA on it right?

[Wheelman]

nice, get a front asa and a 12 quickchange and you'll be all set.

[Big'n slo]

nice, I figured it was kinda obvious and that someone else would have done it, your`unning CA on it right?

Nope, I just slapped that on for testin when I shot the pic a while ago.
I did have a 12g quick change in a VA when it was still in this configuration and it worked decently, But I picked up a sydarm.
So now its mutating again

Edit: fullofpaint, the best quick change I've found is at the bottom of this page.

http://www.whitewolfairsmithing.com/cci%20parts.htm

[syko2102]

Dunno whether its the look you're going for, but at point I considered building a pistol where instead of using the vert adapter, I just used the hole and insead rigged a duckbill to come out horizontally under the barrel. I never actually finished it because I made my custom rig instead, but I can try to illustrate it if you're interested.