Intellifeed?

[DRSP8nt]

I was wondering if or how i could intellifeed, (i think thats the right term), my Spyder e99 avant to my warp, i was told this could be done, but was supicious.

if you have info or instructions please write them

[DRSP8nt]

Ok, i just had an idea that i hope would work, its a long one so bear with me and if you have any comments or helpful hints, please reply.


I was looking at the electronics in the gripframe and, it hit me, couldnt i tap into my E99's trigger switch harness with the harness that comes with the warp and then plug it into the warp? I saw them do this on an angel, not that im saying that my e99's electronics are anywhere near as advanced as the angel's, so then i thought this might not work since i saw this on an angel.

another prob i thought i might have is that i just bought a 25g t-switch and both wires are black, the warp's harness has a black and a red wire, so which wire would i connect to which.

anyway the reason i think this might work is because when i click the trigger a pulse (another prob is on the warp, which jumper would i use, the + or -) is sent to the board telling it to shoot, so wouldnt it also send a signal to the warp to spin every time i pulled the trigger?

thanks for your time in reading this...

[NadeKilla]

trust me when i say this, i know from experience. i try intelli feeding an egg to my spyder long time ago. the board couldnt witstand the egg's battery and it fried the board.

[DRSP8nt]

thanks, would it be the same for the warp?

[NadeKilla]

thanks, would it be the same for the warp?

probably i wouldnt recommend it.

[DRSP8nt]

isnt the egg run off 12 volts, id only be running the warp off of 9.